Safe Instructions

Secure your valuables easily

Follow these simple steps to easily program and use your in-room safe.

Entering User Code

1 – Leave the safe door open and press the reset button C inside the battery compartment. As soon as the yellow LEDs light up and the beeps sound, your desired code can be entered.

2 – Enter your desired user code (3 – 8 digits) and confirm the code with the * or # button.
Your code is now saved. Please make a note of the code or use a code that you will not forget.

3 – Before you close the safe, test the newly saved code. If the yellow LEDs now flash and beeps sound, the code was not ontered successfully. Please try again.

Opening the safe with your Code

1 – Enter your user code and then press the * button. The green LED lights up.

2 –Turn knob A (see Fig. 1) clockwise within 5 seconds of the beep sounding.

3 –To lock the safe again, close the safe door and turn knob A (see Fig. 1) anti-clockwise.

ATTENTION! If the wrong code is entered three times, the safe locks automatically and a warning signal sounds. The keypad is now deactivated. The warning signal can now only be stopped by opening the safe with the emergency key and switching off the power supply by removing the batteries.

Changing the Batteries

When the batteries are low, the green and red LEDs light up together. Open the battery compartment and replace the batteries.

Made with love by QUZERO